Hermes – nearly there!

The 46×1 needles arrived, and I started testing in the machine and immediately continued the breaking and bending of needles! They fit fine, and I am fairly certain the timing was right, but I could not get more than a few stitches out of it. I did a lot of detective work and realized that the feed dogs were trying to move the fabric while the needle was still at the lowest point, eventually bending the needle and causing collisions with the shuttle with obvious distastorous results!

I decided there was an issue with the feed dogs, and stripped down the feed dog mechanism. It did not want to come apart, despite going together quite easily, but eventually I got the crank and cam component off the vertical shaft at the rear of the machine. As I cleaned it up bits started to fall off, and it appeared that the cam that drives the feed dog had broken and three pieces fell out. It may be that I was clumsy removing the crank, or installing during the clean and rebuild, but I feel that something was amiss before then.


Broken feed dog cam

Obviously there is absolutely zero possibility of replacing this part, other than finding another machine, and I was pretty devastated. I put it aside and walked away from it, and basically gave up on it.

A couple of days later I started looking at options. As a minimum I wanted to reassemble the machine as a display model. I reassembled the part using the 4 parts, and realized they fit together quite well. I also realized that there may not be a lot of stress on the parts, so it may be possible to make a repair that would mean the machine could be operated even if it didn’t stitch properly, and if the repair was good enough maybe create a working machine.

The smallest piece was about 2mm across, the next was about 4mm, and the largest piece about 5mm by 6mm, so the only realistic method is to reassemble using super glue. With a magnifying glass, tweezers, patience and innovation, I managed to get all the parts glued together in a reasonable fashion.
I had to smooth the joints between the parts so that the machine worked smoothly without extra wear, and while smoothing the edges and polishing the part, I realized that the cam was not going to fit into the feed dog bar, and needed reshaping to fit. So a major reprofiling of the damaged cam was undertaken, and eventually it was shaped, smoothed and polished to fit.


Repaired feed dog cam

Happy with the shape and the robustness of the repair, I reassembled the machine, and tested the feed dog movements alongside the needle movements. With no other changes, the repaired cam fixed the issue with the feed dogs.
Further testing showed the machine could now stitch successfully, but the timing was off my a small amount, so the next job was to complete the retiming of the needle, shuttle and feed dogs. This took a while to get right, as I made assumptions about what the timing should look like, and I was wrong. In the end instead of timing the needle to the position if the shuttle (incorrectly) I timed it to the movement of the feed dogs and then the shuttle. The clues for the correct timing came from my Singer 28K, which is a vibrating shuttle machine, but has the same “double dip” of the needle at the bottom of it’s stroke. The needle reaches the bottom of its stroke, and the strange eccentric cam follower on the needle bar raises the needle about two to three mm, then drops the needle to the bottom of the stroke again, before continuing with the stitch formation. The shuttle needs to line up with the first pass of the needle through the bottom of the stroke, not the second. I found this counter intuitive, but once I saw the 28k do it, I realized what I had to do. I am still trying to work out exactly why this does what it does. I think it might be making more thread available to make a bigger loop to pass around the shuttle as it passes through the top thread loop.

So at the very least I have a temporary fix and a machine I can demonstrate, and at best I may have a working machine!

A rescue machine from a charity shop costing $100NZ, some expensive needles and a lot of time patience and persistence, and I have a pretty special machine. I did manage to break or bend 5 of my new 46×1 needles, maybe I will keep the remaing 45 needles just in case!